Keep a low profile while drawing the maximum attention. These covert lamps hug the bottom edge of the saddlebags, and provide a subtle band of red light beneath the bike when the ignition is on. To help grab the attention of following drivers, the fast-acting LED lamps increase in intensity when the brakes or turn signals are applied.
- Smoked lens
- Strong adhesive pads secure the water- and shock-proof housings to the bags
- Quick-release wiring harness connects to the bike’s wiring without splicing
- Kit includes left and right lamp and quick-disconnect wiring harness
Disconnecting your DOT requirement brake lamp could reduce your visibility to others and result in death or serious injury.
Electra Glo Stealth Auxiliary LED Run/Brake/Turn Lamp is rated
Rated 4 out of
These should come standard
These were an easy install and fill the gaping holes between the saddlebags and fender. Once installed, they look like they should have been there all along. I think they do what they should do and are visible. They are not as bright as the competition but serve the purpose. My only complaint and or issue I've had with them is, after riding a few hundred miles in the rain, the right one would blink erratically sometimes. I assumed water got in the connection but it appeared sealed very well. Have not noticed any issues since that ride though...
Date published: 2017-11-15
Rated 1 out of
Had dealer install these on '16 CVO Limited. They overpower the system and send out a fault code in the form of a red light on the dash. Numerous trips to the dealer and actual replacement only to find out that Harley has an on going problem with this and at this time no solution for the fix.
Date published: 2017-05-31
Rated 5 out of
These look great.
I had the best dealer in the world, Greeley Harley Davidson, install these. Alex did it himself. They are extremely bright, fit great, and add substantial visibility to the back of the bike. Highly recommend.
Date published: 2017-01-06
Rated 5 out of
Nice additional visibility
I got these to add a little more visibility to the rear of the bike. I wanted something that way plug-and-play so I didn't have to cut into the factory harness and something that was going to work in run/brake/turn mode. These fit that bill to a T! They are very well made and I'm sure they'll last forever. All the wires are wrapped in sturdy insulation which will help protect them from heat, elements, and chaffing. And best of all, they were super-simple to install. They plug in-line with the factory harness and there is no splicing. They're not as bright as my Custom Dynamics LED rear signal/brake lights, but they're plenty bright enough to serve their purpose.
One thing to add that the instructions do not cover: The pigtails coming off the harness that plugs into the factory harness are not labeled for left and right. It's a crapshoot which is which and you will know once you plug them in to test them. I hit my left turn signal and the right one came on. So I swapped the plugs and all is well.
Date published: 2016-12-30