Provides the necessary clearance of the oil tank that allows the Motorcycle Service Lift P/N 94653-98 to be used on '99-later Dyna® models equipped with the Twin Cam engine.
Dyna Twin Cam Service Lift Adapter Kit is rated
Rated 1 out of
Product needs improvement
These are poorly designed. They have started separating during the first use.
Date published: 2017-12-21
Rated 5 out of
these things are really heavy duty, i use them with a flat jack and they even the frame out perfectly. highly recommended.
Date published: 2017-08-16
Rated 3 out of
Does the Job
It does what it was intended to do. The little plastic spacer that goes under the frame extension could have been better designed to actually clamp to the extension rail instead of free floating. You have to guess at where to put it till the last second and then make an adjustment. The other supports snap onto the rails and stay in place. This one could have been designed to do the same but for $25 I can't complain and it does its job.
These frame extenders extend too far in my opinion. Once in place, you barely have room to place the jack. Even with these on my Dyna Low Rider S 2016 it is technically a two man job getting the bike on the jack or a very slow and careful one man job while you sit on the bike to keep it level and work your jack underneath and into position. There is no need for them to be so thick. If they shaved an inch off and redesigned I could slide my jack under and start the lift process with the bike on the jiffy stand.
Again, for $25 I can't complain too much and they do the job.
Date published: 2016-10-12
Rated 4 out of
Dyna frame spacers...
These are exactly what I needed and was looking for an order to be able to use a motorcycle Jack and pick my bike up without it tilting or falling over. These are used to create a level surface sent your frame has a piece of metal that sticks down below the frame on one side.
Date published: 2016-06-18