Chopped Fender Edge Light

Part Number 73416-11


Finish / Color: Red



Style and function in one. This center-mount running and brake light commands the attention of following vehicles. The bright, fast-acting LED lamp glows red when the ignition is on and intensifies when the brakes are applied.

  • LED lamp glows red when the ignition is on, and intensifies when the brakes are applied
  • Low-profile lamp is contoured to hug the curve of the chopped rear fender
  • Adds a stylish touch of color, even when the bike is parked

Bike not listed?
Select your year and model to see all the parts that fit your bike.

  • Model
  • Lighting Type

  • Lighting Color

  • Lens Color

  • Warranty

    1 year limited warranty – Go to for full details
  • Sold in Unit

  • In The Box

    Red lens and all necessary mounting hardware
Chopped Fender Edge Light is rated 4.6 out of 5 by 16.
Rated 5 out of 5 by from Must have This tail light not only looks great, but gives you more light when hitting the brakes, should come stock on all bikes.
Date published: 2017-10-28
Rated 5 out of 5 by from This is one sharp light It didn't perfectly fit my rear fender. There were small gaps on either side between the light and fender. But when this lamp is centered (or centered well enough), it really adds something special to the bike ('12 FXDWG) This lamp offers form and function. It belongs on your bike.
Date published: 2016-07-24
Rated 5 out of 5 by from Nice looking light the light fits great and looks good. the install was easy. it could be brighter, but very happy with it.
Date published: 2016-06-03
Rated 4 out of 5 by from Needs more light Install was easy and added much needed light at the rear of the bike- should have come standard!
Date published: 2016-05-06
  • y_2018, m_2, d_26, h_20
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.7
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_16
  • loc_en_US, sid_PA-11-7341611, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_harleydavidson

will this fit rear fender on 2016-17 fxdls what are the overall measurements, end to end

not worried about wiring , we will figure that out.
Asked by: HGlide


I would think that this light will fit not only Wide Glide, but Street Bob and Low Rider S as well. Any input anyone? They all have the same fender and turn signals after what 2015 or 2016?
Asked by: kevin211

Included Clips Failed

I just wanted to point out a significant failure of the included clips to both stick to the inside of the fender and to hold the cabling in place. After taking off my rear fender (for other reasons) and cleaning it thoroughly, I installed the Chopped Fender Edge Light using the included 4 clips to route the cable on the underside of the fender. This was 2 months ago. However, yesterday I discovered the cable dangling next to the tire and, upon jacking the bike up to look under the fender, found the cable shielding worn away along with the individual wire protective casings, leaving 2 of the wires frayed and exposed. In addition, two of the four metal clips had fallen off. Thus, in a span of 2 months, the clips failed to hold the cabling in place and 50% of the clips had failed to stick to the inside of the fender. This left the cabling permanently damaged. I warn everyone buying this kit to watching how you route the cabling: do NOT use the included metal clips and use ONLY the factory cable routing guides. Otherwise, you will be left with a damaged product as I currently am. Harley-Davidson, how will you correct this product failure?
Asked by: SilverFox

I have a FXDWG 2014 International model just had this light installed last week. The security light is on constant (red light Speedo)

Does this LED mess with the computer. The tech I spoke to said it can not be rectified but won't hurt the bike. But have heard on forums that the BCM can be reprogrammed to run this light. Also could be caused by the computer recognizing a voltage change. Can you please help I love the look of this light but not at the expense of my bike.
Asked by: Brockaruss14

2012 FXDWG - Is the chopped fender edge light compatible with License plate, turn signal relocation kit No:68544-10?

Asked by: NewDog75
  • y_2018, m_2, d_26, h_20CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.7
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_9
  • loc_en_US, sid_PA-11-7341611, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_harleydavidson

Recently Viewed

    Please Hold Your Iron Horses

    You've been sitting idle, so we've ended your session to protect your personal details.

    Continue as guest Sign in
    Online Exclusives

    You’ve been sitting idle, so your session will expire in

    Would you like to remain signed in and continue shopping?

    Yes, keep me signed in No, sign me out

    Prices listed are generally the Manufacturer's Suggested Retail Price (MSRP), excluding taxes and shipping. Prices at local dealerships may vary. All online orders will be fulfilled and shipped by
    Harley-Davidson Motor Company as the agent for the Selling Dealer.