These Auxiliary Power switches allow you to control additional fog lamps, auxiliary lighting, heated gear or electrical accessories with the touch of a finger.
- Styled to match the Original Equipment fairing dash panel switches
- Kit includes two auxiliary switches, wire harnesses and installation hardware
Auxiliary Power Switch Kit - Fairing Mount is rated
Rated 4 out of
As the title says simple installation, but for the cost, it could have come with a few different buttons to indicate various connections instead of have two that say "AUX". Also, there are three buttons on each side of the control panel but this came with only two, Why?
Date published: 2017-04-26
Rated 5 out of
Switch arrived in good order and on time. Wiring harness doesn't mate up to anything on my bike. Existing wiring mated right up to the switch. I couldn't locate any sockets that the switches controlled. Ended up having to tap into the wires coming directly out of the switches to make my passing lights work properly.
Date published: 2017-04-21
Rated 5 out of
This kit is a simple plug and play addition!
I installed PASSING lights on my 2015 SGS and purchased this kit because it came with the switch housing and the wiring harness. I wanted to use the factory switch housing to access the driving light circuit and this kit also allowed me to install two auxiliary circuits, for later use, at the same time. This is an AUXILIARY wiring kit! Use it to add heated grips, heated seat, etc like it says. If you want to add fairing mounted driving lights, you will also need to order the light switch button HD P/N 71400044 separately and install it into the switch housing (very easy for a novice even). The switch housing is configurable so don't be afraid to open it up via the four tabs on the housing, you have to to add the light button. No springs or parts will come flying out! This picture shows two buttons out of the switch housing but mine arrived already assembled.
The dash housing can be easily removed to take out the factory blank and install the switch housing without taking out the ignition switch. I just did it.
My bike is already pre-wired for a driving light circuit so I ordered the addition light button, installed it into the switch housing, plugged in the factory harness and I'm off to the races. It was that simple, literally took 30 or so minutes, and a novice can easily do this install given some more time. I also have two accessory circuits now ready to go.
The price might seem steep but for all you get from this kit and the ease of install I personally think it was worth the few extra bucks to do the job correctly and add a couple extra circuits. I highly recommend this kit if you want to add extra circuits.
Date published: 2017-03-10
Rated 4 out of
Looks great and functional, but...
Wanted to add the auxiliary switch to control my aftermarket crash guard lighting. The switches look great and operate as desired. My only issue is that for this price, why wouldn't it come with all 3 switches? It only comes with 2 and one dummy. Both are labeled AUX. Asked my parts counter and you can purchase a 3rd "Lighting" switch for $17. Anyway, I needed/wanted them, so paid the price, but feel it a bit of an unnecessary money grab.
Date published: 2016-10-17