Rated 5 out of 5 by 6
Rated 5 out of 5 by maximus1 Skull Footboard covers
Decided to add a bit of Skull to my bike. Subtle skull with a lot of chrome.Nice fit with easy installation. Needed to drill a couple of holes for the self tapping screws, very easy. Really adds a nice touch to bike along with the new footbaord and brake pedal pad.
July 25, 2016
Rated 5 out of 5 by LTC489Lester More Chrome please -- thanks
Yet again here is another example whereby Harley-Davidson is notorious for selling you an awesome motorcycle fully KNOWING that you will need to, at some point, accessorize. I really love the way these looked and I had these installed by the professionals at Smokey Mountain Harley-Davidson in Maryville, Tennessee. They did a very nice job; as always. The Warden (wife) hasn’t noticed these (and isn’t wild about skulls) but I think these are small enough that it won’t be terribly noticeable. We’ll see if she notices them. Love the look and highly recommend. Thank you!
April 12, 2016
Rated 5 out of 5 by Joker2016 Great Product Easy to Install
Like another reviewer mentioned, these are so easy to install but throw the instructions away. They make installation way to complicated and do not tell you what size drill bit to use, which I found odd. I placed the cover over the footboard, used a 5/38" drill bit, drilled my holes using medium pressure, screwed in the self-tapping screws and was done. Starting the screws requires some effort but they will go in. 10 minutes and you're done. The only thing that disappointed me was that the dealer ship was going to charge me $25 for a 10 minute job. Really?
March 12, 2016
Rated 5 out of 5 by thomasnruth Very Easy Installation
I installed these on my 2015 Ultra Classic. Very easy install, less than 10 minutes. Requires drilling two holes in each foot-board using a 5/32 drill bit, and Phillips head screwdriver to mount. Forget what the instructions say, no disassemble of your foot-boards required. Hold the chrome covers up to the foot board firmly in place, then start to drill slowly with little pressure. Get each hole started then remove the cover and complete the drilling. The foot-boards are made from cast aluminum so not much pressure is needed. The screws are self-tapping. Completed, these look great and adds another piece of class to your Harley. Recommended.
May 1, 2015