Rated 3.7 out of 5 by 6
Rated 5 out of 5 by DG335 Awesome Looking Part!
I thought this was relatively painless as installs go. I agree w/ previous poster, take the gas cap off and stick in a rag, it gives you much better access to the screws. 1/4" socket worked best for me. Yes, you will need to thread the new ones in but just get them started with the ratchet and they will go right in. Also, make sure the lock is right at 90 degrees when you put it on the new cover or it might not catch when closed.
November 24, 2014
Rated 5 out of 5 by SteveP48 Love Willie G stuff.
For those that suggest no threads...the factory screws are self tapping...run them in with a 1/4" nut driver first. Pre fit to the bike.
Then a drop of blue lock tight, snug up with a 1/4" drive and done.
Tip...on my 14 Ultra, I took the gas cap off and stuffed a rag in the tank...no dropping stuff in the tank and easier to get to the screws.
Factory used lock tight on original cap cover
October 31, 2014
Rated 5 out of 5 by Bustem4ems Awesome Part
Installed in minutes with ease, has good fit and finish, improved the look of my bike would recommend to everyone.
August 26, 2014
Rated 1 out of 5 by chaz Product is defective
Purchased product at out of town dealership I was visiting. While trying to install I came to realize that there were not any threads machined in the bolt holes!!!!
July 5, 2014