Free Shipping to your local H-D® Dealership on all orders. Details

Air Wing Luggage Rack LED Light Kit-68250-08A

Part Number 68250-08A

Quantity:

A A A

Custom fit to the Air Wing Tour-Pak® Rack, this fast acting LED Light Kit operates as a supplemental rear running light and brake light.

  • Fast-acting LED Light Kit operates as a supplemental rear running light and brake light
  • High, center-mount position places the light in the line of sight of following vehicles
  • Bright, fast-acting red LED lamps get you noticed
  • Wiring is concealed inside the rack tubes for a clean, custom installation
  • Red lens
A A A

Fits '09-'13 Touring models equipped with Air Wing Detachable Luggage Rack P/N 54283-09 and 50300008. Does not fit CVO™ models.

Bike not listed?
Select your year and model to see all the parts that fit your bike.

Shop
  • Lighting Type
    LED
  • Lighting Color
    Red
  • Lens Color
    Red
  • Warranty
    1 year limited warranty - See Customer Service section for details
  • Sold in Unit
    Each
  • In The Box
    LED light assembly, all necessary mounting hardware and installation instructions
Rated 4 out of 5 by 1 reviewer.
Rated 4 out of 5 by Nice add on - easy install This LED light was easy to install. Took me maybe an hour. The instructions refer to the HD service manual for the connector assembly. You should have the service manual any way...quit being a cheap-ass and get one! The only difficult part to the install was getting the wires through the bolt that holds the luggage rack on. I used a squirt of WD40 on the wires to help slide them through. Another thing I did was to reuse the silicone plug from the luggage rack to seal the opening for the wires. I sliced a little bit off the side of the plug with a sharp knife to make way for the wires. The lights work great and I like the idea of having more lights up high for cagers to see when I'm stopping July 14, 2013
1-1 of 1
Ask your questions. Share your answers.
2 Questions | 1 Answer

Product Q&A

Ask your questions. Share your answers.

 
 
« Back
 
 
AIR WING RACK LED LIGHT KIT
July 13, 2013
Customer avatar
by
Read all my Q&A
 
Please wait while more information about Dexter is loaded.
Additional information about Dexter could not be loaded.
I Ride: Road Glide Ultra
-1point
0out of 1found this question helpful.
Was this helpful?helpful0unhelpful1

Answers

Answer: 
Hey Dexter, the easiest way for me to answer this is to give you the segment from the Instruction Sheet. Hope that's cool with you?!?

14. Locate and disconnect three pin AMP connector for Tour-
Pak lights.
15. See Figure 3. Attach the Y-harness (2) to the three pin
male connector (1) of Tour-Pak harness.
16. Route light wires from back of Tour-Pak along left side to
front. Secure conduit with adhesive clips provided in kit.
17. Trim length of light wires and conduit to reach Y-harness.
18. Refer to the Service Manual electrical appendix to install
terminal pins (8) to rack light wires and install terminals to
three pin housing (7) as follows:
a. #1 cavity = blue lead
b. #2 cavity = red with yellow lead
c. #3 cavity = black lead
19. Connect rack light to remaining Y-harness connector.
August 22, 2013
Customer avatar
by
Read all my Q&A
 
Please wait while more information about RockyXL883 is loaded.
Additional information about RockyXL883 could not be loaded.
Milwaukee, WI, USA
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
air wing rack led light kit
October 30, 2013
Customer avatar
by
Read all my Q&A
 
Please wait while more information about perry is loaded.
Additional information about perry could not be loaded.
new carlisle,ohio
I Ride: 2013 trike
How I Ride: Touring - With Passenger
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0
1 of 1
1 of 1

You Might Also Like

Recently Viewed