Rated 3.8 out of 5 by 16
Rated 3 out of 5 by Soonerpepa Less than expected
My '13 FLTRU has limited rear lighting, so I added this as a safety measure. Not really much benefit as a "running" light in the daytime, but it does add some noticeability when braking. A minor amount of added light for running at night, and a nice addition for braking in the dark. Very easy to install; took me about 30 minutes. Overall worth the 70 bucks, but not if you pay another $75 -$90 in HD dealership labor.
May 25, 2016
Rated 5 out of 5 by steelersman1 product was great
looks really nice, love the extra lights,easy to add on
December 29, 2015
Rated 1 out of 5 by consitter Dim and slanted toward ground
I was disappointed in this light. It is too dim for good use. That being coupled with the fact that it is slanted toward the ground doesn't help matters any. It does not do any good as far as safety is concerned. I feel like I wasted my money.
October 4, 2015
Rated 1 out of 5 by Egress60 Air Wing Rack LED Light Kit
I installed this at the same time with my lid rails. The wire harness on these lights both come out on the same side (left), not a left/right configuration as you would expect. The left side went on great, the right side....not so much. I had to redrill a 3/8 hole for the harness as it came down into the lid. The routing on the right side where the wire harness comes through runs from the INSIDE of the right lid towards the hinge point. This forced me to use a clamp to secure the wire and route it back towards the outside hinge area to prevent excessive slack and pinching. The wiring harnesses on these light should be configured so they are on the outside towards the hinge area.
The instructions say to insert the wires into cavity 1, 2, and 3 which are not marked on socket housing. But using common sense, you can figure it out.
I expected the LED lights to be brighter for daytime visibility. They look great at night.
Unless you have some mechanical expertise, do not attempt this installation by yourself until HD redesigns the wiring harness properly.
August 24, 2015